|
All machines moulding thermoplastics need some form of cooling.This cooling is needed, to apply to the mould to set the article and partly for the machine moulding the product. Depending on the weather conditions and humidity levels in the place where the machine is being run, manufacturers use either chilling plants or cooling towers or both for meeting their cooling needs.
Cooling towers depending on their make are enclosures housing a pvc mesh fill, fan(s), and a collector tank below. The hot water is pumped out from the mould and fitted to the inlet of the cooling tower. The inlet which is generally at the top lets the water fall onto the pvc mesh fill, and accompanied by the cool air blown by the fan at the top of the cooling tower the cooled water percolates through the mesh and collects in the tank below and is pumped back to the mould.
Specifications of our range of Cooling Towers are as follows:
Model |
Length (mm) |
Width (mm) |
Height (mm) |
Motor (HP) |
Fan Dia (mm) |
Water Inlet (Inch) |
|
600 |
600 |
1000 |
0.50 |
450 |
1.5 |
|
750 |
750 |
1350 |
0.50 |
450 |
1.5 |
|
750 |
750 |
1350 |
0.50 |
450 |
1.5 |
|
750 |
750 |
1650 |
0.50 |
450 |
2.0 |
|
900 |
900 |
1800 |
1.00 |
600 |
2.5 |
|
1050 |
1050 |
1800 |
1.00 |
600 |
2.5 |
|
1050 |
1050 |
1800 |
1.50 |
600 |
2.5 |
|
1200 |
1200 |
2100 |
1.50 |
750 |
3.0 |
|
1200 |
1200 |
2200 |
2.00 |
750 |
3.0 |
|
1350 |
1350 |
2200 |
2.00 |
880 |
3.0 |
|
1200 |
1200 |
2400 |
2.00 |
750 |
3.0 |
|
1500 |
1500 |
2400 |
3.00 |
880 |
4.0 |
|
1650 |
1650 |
2550 |
3.00 |
1200 |
4.0 |
|
1800 |
1800 |
3000 |
3.00 |
1450 |
4.0 |
|
1800 |
1800 |
3300 |
5.00 |
1450 |
4.0 |
|
2100 |
2100 |
3000 |
7.50 |
1450 |
5.0 |
|
2550 |
2550 |
3300 |
7.50 |
1900 |
5.0 |
|
2550 |
2550 |
3300 |
10.00 |
1900 |
6.0 |
|
3000 |
3000 |
3450 |
10.00 |
1900 |
6.0 |
|
3750 |
3750 |
3900 |
10.00 |
2380 |
6.0 |
|
3750 |
3750 |
3900 |
12.50 |
2390 |
8.0 |
Product Specifications may change without notice.
|
